1000kg Trail-type small platform folding scissor lift with extension platform
1. The lifting platform has been inspected and debugged at the factory before delivery. All the technical indexes have reached the design requirements. When using, the lifting platform only needs to be connected with the power supply, and the hydraulic system and electrical system need not to be adjusted.
2. The platform should be carefully checked before use of hydraulic, electrical systems, no leakage or naked leakage before use.
3. Lifting platform in use, the four legs should be firmly supported on a solid ground (with the wheel to leave the ground shall prevail) if necessary, the use of sleepers.
4. Lifting platform empty run 1-3 times before loading operation.
5. load center of gravity should be as far as possible in the center of the table.
6. Guard railings at both ends of the movable door should be locked after the lock operation.
1, Maintenance introduction
a. Wheels, countershafts and bearings, cylinder pin and bearing, jib hinge shaft and bearing wear.
b. All parts are filled with some lubricants to extend the service life of bearings.
c. Hydraulic oil and oil level. Lifting platform throughout the rise, in this position, the hydraulic floor should be higher than the bottom 40 to 50 mm. If it is found that the hydraulic oil is dark, sticky or gravel and other foreign objects should be promptly replaced (winter replacement 32 # hydraulic oil, summer 46 # hydraulic oil. In particularly cold northeast, should be replaced transformer hydraulic oil).
2, Mid-year inspection
a, According to the order of six months or 500 hours prioritized.
b, The whole platform will rise and fall, into a brace.
Product Tags:
|
|
1000kg Aerial Lifting Platform Images
|
